Lollar Electric

For homeowners

EV charger installation in Prescott

Lollar Electric installs electric vehicle chargers at homes in the Prescott area. We check that your electrical system can carry the added load, run the new circuit, and wire the charger so it meets code.

How a home charger install goes

  1. We look at your panel

    A 240-volt home car charger (often called Level 2) is one of the largest loads in a house. Before anything is installed we check the size of your electrical service and how much of it is already in use.

  2. We agree on where it goes

    The closer the charger is to the panel, the shorter the wire run. We look at where you park, which side the car's charge port is on, and whether the charger will be indoors or out in the weather.

  3. We run the circuit

    A new breaker in the panel, wire sized for the charger, and conduit where the run is exposed. A charger in a detached garage takes more work than one mounted near the panel.

  4. We mount, connect and test

    The charger is wired, powered up and tested before we leave.

Hardwired or plug-in for Level 2 charging?

A hardwired charger is connected directly to its circuit. A plug-in charger uses a 240-volt outlet, which has to match the charger's plug and suit the spot where it is mounted. We install either kind.

Read the charger's installation instructions before you buy. They say which way that model can be installed and what circuit it needs. If you have not picked a charger yet, tell us the car and we can talk through it.

What changes the scope of a home charger installation?

Two homes on the same street can need very different amounts of work for the same charger. These are the things that change it:

  • Room in the panel. If the panel has open spaces and the service has capacity to spare, the charger gets its own breaker. If the panel is full or the service is small, more work is needed first. See panel upgrades and service changes.
  • Distance. A charger mounted next to the panel takes less wire and labor than one on the far side of the house.
  • Charger size. Chargers come in different amperages. A higher-amp charger fills the battery faster and needs heavier wire and a larger breaker.

When you compare quotes, check whether each one includes the charger itself and the permit.

What should I have ready before I call?

These are the details that decide the job. Have as many as you can:

  • The make and model of the car, and of the charger if you have picked one.
  • Where the car parks, and which side its charge port is on.
  • Whether the charger will be in a garage or outside in the weather.
  • Where the electrical panel is, and about how far it is from the parking spot.
  • Large electric loads the house already has, such as electric heat, a range, a dryer or a well pump.
  • The property address, which decides the permit office.

EV charger questions

Can my house handle an EV charger?

Most can, but not all without changes. It depends on the size of your electrical service and what is already running on it: electric heat, a range, a dryer, a hot tub, a well pump. We check that before installing anything, because a charger added to a system with no spare capacity will trip breakers or overheat wiring.

Do I need a permit to install an EV charger in the Prescott area?

Usually, yes. A new 240-volt circuit normally needs an electrical permit from the building department for your address: your city or town, or Yavapai County outside town limits. Our service area pages name the office for each town.

What is the difference between Level 1 and Level 2 charging?

Level 1 charging uses a regular 120-volt outlet and is the slower of the two. Level 2 uses 240 volts, the same voltage as an electric dryer, and charges faster. Level 2 is what most people mean by a home charger, and it needs its own circuit put in by an electrician. The U.S. Department of Energy explains both levels.

Do you install chargers for businesses?

This page covers chargers at homes. Lollar Electric also does commercial electrical work. For a charger at a business, call the office at 928-778-2523 and ask.

More questions and answers

Where we do EV charger installation

We install car chargers at homes across the Quad Cities and Yavapai County.

Getting an electric vehicle?

Call 928-778-2523 and tell us what you drive and where you park. We will tell you what your house needs.

Page updated

Call nowRequest a quote