For homeowners
Lighting and ceiling fan installation
Lollar Electric installs and upgrades lighting in homes around Prescott. We replace old fixtures, install indoor and outdoor ceiling fans, add lights where there are none, and run the wiring and switches that go with them.

Common lighting and ceiling fan jobs
Most home lighting and ceiling fan jobs fall into one of these:
- Replacing a fixture. The old fixture comes down and the new one goes up on the same box and the same switch. This is the smallest lighting job, unless the new fixture is much heavier than the old one.
- Adding a light where there is none. A room with no ceiling light gets a new box, a cable run to it, and a switch on the wall. Recessed lights in a kitchen or living room are the usual example.
- Installing a ceiling fan. Indoors or outdoors. A fan has to hang from a ceiling box rated to hold a fan, which an ordinary light box may not be.
- Hanging a heavy fixture. A chandelier in a two-story entry has to hang from a box and bracing rated for its weight, and someone has to reach it safely to hang it.
- Changing the controls. A dimmer in place of a plain switch, a second switch at the other end of a hallway or stairs, or one bank of lights split into two.
What decides how big a job it is
How much work a light takes depends on four things:
- Whether power is already there. A fixture going onto an existing box is a short job. A light in a new spot means a new box and a new cable.
- What is above the ceiling. With an open attic, cable can usually be run without cutting drywall. A finished floor above, a flat roof or a vaulted ceiling makes the run harder, and some patching may follow.
- The circuit. A few LED fixtures add little load and can usually join an existing lighting circuit. A large addition may call for a new circuit.
- Moisture. A fixture in a shower, over a tub or outdoors has to be rated for damp or wet locations.
If the house is still being built, lighting is part of new home wiring.
Lighting questions
Can you add a ceiling light to a room that does not have one?
Yes. Adding a ceiling light to a room without one means mounting a new electrical box in the ceiling, running cable to it from a power source, and installing a wall switch. In a single-story house with attic access, the cable can usually be run without cutting into finished walls. Where there is a floor above, some drywall may have to be opened and patched afterward.
Why do my LED lights flicker or buzz on a dimmer?
LED lights flicker or buzz on a dimmer when the dimmer was made for incandescent bulbs or the bulb is not a dimmable type. Older dimmers expect a much larger load than a few LED bulbs draw. The usual fix is a dimmer rated for LED loads, paired with bulbs marked dimmable. If lights flicker with no dimmer involved, the cause may be a loose connection, which is a job for troubleshooting and repair.
Can a chandelier hang from a regular ceiling box?
Not always. A standard ceiling box is rated to support a light fixture of up to 50 pounds, and only if the box itself is fastened securely to the framing. A heavier chandelier has to be supported independently of the box, or hung from a box rated for that weight. Before a heavy fixture goes up, the box and how it is attached should be checked, not assumed.
Should I buy my light fixtures before calling an electrician?
You can call an electrician before or after choosing light fixtures. If you have already picked them, have the model number or a photo of the box label ready, because a fixture's weight, its size and whether it is rated for damp locations all affect how it is installed. If you have not, an electrician can tell you what your ceiling boxes and wiring will support.
Where we do lighting and ceiling fan installation
We install and upgrade home lighting across the Quad Cities and Yavapai County.
Want better light in the house?
Call 928-778-2523 and tell us which rooms and what is there now. Or use the request a quote form.
Page updated
